Riverstone Networks WICT1-12 Especificações descarregar pdf (Página 66)

3-16 Riverstone Networks RS 32000 Switch Router Getting Started Guide

Installing the Hardware Hardware Installation

Figure 3-10 Inserting a GBIC module

2. Gently insert the GBIC module into the GBIC slot opening. The GBIC door on the line card folds

in, and the internal guides engage the alignment slots on the sides of the GBIC module.

Warning If the GBIC module does not go in easily, do not force it. If the GBIC is not

oriented properly, it will stop about one quarter of the way into the slot and

should not be forced any further. Remove and reorient the GBIC module so

that it slides easily into the slot.

3. Push the GBIC module in until the connector engages the 20-pin port. The GBIC is now installed.

3.3.9 Attaching the Segment Cables

With your RS 32000 installed and connected to a management console, you are now ready to attach the RS 32000’s

line cards to your network. The RS 32000 uses industry standard copper and fiber cables and connectors. For

information regarding required connector types, cable types, and pin-out assignments, see the tables associated with

each line card in Chapter 2, "Introduction."

Proceed to Chapter 4, "Initial Configuration" for instructions about powering on the RS 32000 and performing initial

configuration.

Insert GBIC through spring-loaded

door. GBIC is keyed, and will

fit only if orientation correctly.

To remove,

press tabs on

top and bottom

of GBIC and pull.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 110 111

Sem comentários

Riverstone Networks WICT1-12 Especificações Página 66